Evolution of Shore Hardness under Uniaxial Tension/Compression in Body-Temperature Programmable Elastic Shape Memory Hybrids.

Body-temperature programmable elastic shape memory hybrids (SMHs) have great potential for the comfortable fitting of wearable devices. Traditionally, shore hardness is commonly used in the characterization of elastic materials. In this paper, the evolution of shore hardness in body-temperature programmable elastic SMHs upon cyclic loading, and during the shape memory cycle, is systematically investigated. Upon cyclic loading, similar to the Mullins effect, significant softening appears, when the applied strain is over a certain value. On the other hand, after programming, in general, the measured hardness increases with increase in programming strain. However, for certain surfaces, the hardness decreases slightly and then increases rapidly. The underlying mechanism for this phenomenon is explained by the formation of micro-gaps between the inclusion and the matrix after programming. After heating, to melt the inclusions, all samples (both cyclically loaded and programmed) largely recover their original hardness.

Body-Temperature Programmable Soft-Shape Memory Hybrid Sponges for Comfort Fitting.

Porous shape memory hybrids are fabricated with different matrix (silicone) hardness and different inclusion (polycaprolactone, PCL) ratios. They are characterized to obtain their mechanical response to cyclic loads (with/without pre-straining/programming) and their shape memory performances after body-temperature programming are investigated. These materials are lightweight due to their porous structures. Wetted hydrogels used in the fabrication process for creating pores are reusable and hence this process is eco-friendly. These porous shape memory hybrids exhibit the good shape memory effect of around 90% with higher inclusion (PCL) ratios, which is better than the solid versions reported in the literature. Hence, it is concluded that these materials have great potential to be used in, for instance, insoles and soles for comfort fitting, as demonstrated.

A Brief Review of the Shape Memory Phenomena in Polymers and Their Typical Sensor Applications.

In this brief review, an introduction of the underlying mechanisms for the shape memory effect (SME) and various shape memory phenomena in polymers is presented first. After that, a summary of typical applications in sensors based on either heating or wetting activated shape recovery using largely commercial engineering polymers, which are programmed by means of in-plane pre-deformation (load applied in the length/width direction) or out-of-plane pre-deformation (load applied in the thickness direction), is presented. As demonstrated by a number of examples, many low-cost engineering polymers are well suited to, for instance, anti-counterfeit and over-heating/wetting monitoring applications via visual sensation and/or tactual sensation, and many existing technologies and products (e.g., holography, 3D printing, nano-imprinting, electro-spinning, lenticular lens, Fresnel lens, QR/bar code, Moiré pattern, FRID, structural coloring, etc.) can be integrated with the shape memory feature.